There’s no shortage of techniques for make mortise and also tenon joints. Numerous of them depend on the tablesaw but the results are not always perfect. The classic table observed tenoning jig boosts on this by hold the workpiece vertically permitting the cheek cut to come to be “rip” cuts leading to a quite smooth repeatable cut. Tenoning jigs haven’t changed in decades and most of lock look choose they came out of the specific same factory. When they are serviceable, there certainly was room because that improvement. Nobody bothered till now. Go into the Powermatic PM-TJ Tenoning Jig. It’s lighter, it’s more accurate, it’s easier to adjust, and it just looks cool!

Setup & Performance

*
After unboxing, i went with the calibration procedure outlined in the manual. This just takes a couple of minutes and once you perform a test cut, you have an chance to use the micro-adjustment dial to fine-tune the jig. Ns assumed that from that point on I’d likely need to use the micro-adjustment dial to fine track all future cuts, but I was pleasantly surprised to find that wasn’t true. When calibrated, the jig seemed to work-related flawlessly no issue the dimension of the tenon or the size of the workpiece. As lengthy as you’re consistent around the lot of push you use to your protect against blocks as soon as doing the setup, you will most likely never need the micro-adjust. I assumed this was pretty remarkable and that’s why i chose the two tenon setup as part of this demonstration.

Should you Buy One?

Obviously this is a challenging question for me come answer due to the fact that it counts on your personal situation. Yet if you make a many of classic mortise and also tenon joints where the mortises are cut with one of two people a router or a hole chisel mortiser, this is a jig friend should probably consider. Simply note the if you execute angled tenons, you might have to construct an add-on that screws come the challenge plate. When the jig does permit angled cuts from front come back, the does not pivot from side to side. The older tenoning jigs DO change in both directions. In every the year I’ve owned a tenoning jig I deserve to only think of one occasion where I essential the next to next angle feature however depending on the occupational you do, this might be a consideration.

All told, this jig does one job and also it does that remarkably well. It’s a far-reaching improvement over the “hunt and peck” style setup of the older jigs and produces perfect results without ever before having to measure up or draw layout lines. If you’re in the market, examine it out!

Disclosure: This is a funded video.


You are watching: Powermatic pm-tj tenoning jig


See more: Y=-3X-2 - And Parallel To Y = 3X

Powermatic noted me with the jig in exchange for review/exposure. They did not, however, affect the opinions express in the video and writeup.